Hub Bearing Dust Cap Bicycle
Description
PDFPlastic version of a metal dust cap for a bicycle front wheel.
It pushes over the bearing cone and the outer lip is meant to fit lightly into a groove in the rubber seal that is in the center of the wheel.
It acts as additional protection from dirt and water. This design is very common on older and cheap bikes.
Dimensions of the one pictured are for the 3/8th (9.53mm) axle.
ID = 17.2mm
OD = 25mm
Inner Lip Height = 1.0mm
Outer Lip Height = 1.5mm
2nd Aug 2021 :-
Added dust cap for the 5/6th (7.95mm) axle. (Let me know of the dimensions are correct)
ID = 14.86mm
OD = 21mm
Inner Lip Height = 1.0mm
Outer Lip Height = 1.5mm
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
Yes
Supports:
No
Resolution:
0.10mm Layer Height
Infill:
100%
Filament:
Any PLA
Notes:
It can be hard to remove from the bed with distorting or breaking it. Using raft will make it easier to remove.
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
