This is an adaptation of MFBS "Fast-Swap series" to improve weigth while retaining rigidity for MGN9H rails.
[20220714] New top mount design featuring integrated slots for endstop.
Other compatibilities with original EVA 2.4 remain but you can also consider one of my other mods like XY-joiners reinforced for carbon gantry or tensionner-less back plate.
For assembly you should use brass inserts from Ruthex (or similar): short M3x4.6x4mm
A smart solution to move tensioners on printer frame can be found here: https://store.brs-engineering.com/
This design has been developed from Pawel Kucmus's brilliant EVA eco system and inherits the same GPL license a the original.
This is not intended to be a replacement for the EVA system but rather a mod that better supports a limited range of hot ends and extruders.
For more information on the brilliant EVA system please see: https://main.eva-3d.page/
Printer:
RatRig Vcore-3
Rafts:
No
Supports:
Yes (Only for top mount from build plate)
Resolution:
0.2
Infill:
30%
Filament:
/ /
Category: 3D Printer Parts
The author marked this model as their own original creation. Imported from Thingiverse.