Command Strip Speaker Mount

I wasn't able to put a nail in the wall where I wanted my speakers, so I designed this. It has a small groove on the back which fits around a large command strip, and it is sized so that the tab will still stick out the bottom. The stem and bulb are made to fit the speakers I have, they might not fit everything though.

When printed in the orientation of the file it comes out pretty sturdy, though admittedly I haven't been using it for long, so hopefully there isn't any delamination.

Use this Thing at your own risk, make sure your final print is strong enough to support whatever you're hanging on it.

Print instructions

Category: Household Print Settings

Resolution: .2mm

Notes:

For the best durability, I would suggest printing it on one end so that the stem is sticking out parallel to the ground.