BTT Smart Filament Runout Sensor Mount

Having recently fitted support rods to my Ender 3 v2, it became clear that the BTT Smart Filament Run-out Sensor needed a new mounting point otherwise it would crash into the support rods near the top of the build volume.

This mount fixes to the rear plate for the X-axis. It uses two wheel nuts to stay in place.

There is roughly 11cm of PTFE tubing required to go from the sensor to the extruder block.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.2mm

Infill:

20%

Filament: eSun PLA

Notes:

Supports are necessary for the inside of the holes used for attaching to the rear of the x-axis plate.