EP-PG900IBE Charger Stand for Samsung Galaxy Note 9 in a Otterbox Case

I was looking for a stand for my phone, a Samsung Galaxy Note 9 that could hold my old Samsung EP-PG900IBE square charger that I had laying around and I found david4974's old S6 one and used TinkerCAD to modify it.

I exploded it into about 16 pieces and modified it to hold my Note 9 while still keeping it in its bulky Otterbox case.

The speaker hole has been realigned correctly out the bottom, and the charger has been raised to work with the Note's internal wireless charger location. The whole thing is a bit bulkier and takes about 3.5 hours to print at 80mm/s at 0.3 layer height with 20% infill.

Print Settings

Printer Brand:

Anet

Printer:

A8

Rafts:

No

Supports:

Yes

Resolution:

0.3

Infill:

20

Notes:

Print it in whatever resolution up to 0.3 that you want, higher will take longer.

I used a brim to keep it stuck to the build plate a little better and tree supports for the very top, bottom and status light see through.