Mac Keyboard (Lower) Riser Stand with Angle

I recently created a Mac Keyboard riser with angle and decided I wanted a short version, too. Here I've remixed the original design so the rise is about 1.25" instead of about 3.25".

Print two "base.stl" and one of each of the others.

The orientation should be correct as distributed so you only need supports for "middle.stl".

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

No

Supports:

Yes

Resolution:

0.2mm

Infill:

35%

Filament: Hatchbox PLA, 1.75 White and Gold

Notes:

Print in provided orientation.

Post-Printing

Use CA / super glue to assemble the pieces.

Tolerances are tight. It assembles fine when printed from my Prusa i3 MK3. If too tonight to assemble the pieces, some sanding might help.

I used "Gear Gripz" (the adhesive black hex dots in the photos, purchased from Amazon) to on the bottom and on the angled part to help keep the stand and keyboard in place. This has proven effective for me.

How I Designed This

Designed with digital calipers and a bit of intuition in Fusion 360.