Outdoor Solar Lights panel Holder

My wife decided to run LED solar string lights along various fencing etc. With small gardens placing the solar panels on the floor would not give them much time in the sun.

 Currently 3 versions available, we have curved fencing so produced vertical and a left and right slanted version. 

The cylindrical whole going through the middle goes from 15.5mm to 14.5mm and accommodates the 15mm cylinder attached to solar panel. Allowing it to be pushed in and held firm.

To help out the word “top” is printed as you guessed it at the top (15.5mm end). Screw holes 5mm (screws in picture 4mm) Screw Plate 65mm, shaft 60mm

Printed 0.15 setting 15% infill

14/05/2022: Updated files as tapered screw holes were on the back and added with fusion 360 File

14/05/2022. Added longer and larger 25mm Version. Along with “Freecad” File to help make changes easier

16/05/2022 Added 15mm Corner Version and Freecad file. Printed on a 0.30 setting and 20% infill . No supports needed to print when printing from top up as picture shows.