Enclosure LED Light Strip Cove

I'm building an Ikea Melltorp enclosure for a CR-10S and wanted a cheap lighting option. Purchased a LED light strip but realized if they are just stuck up there the bulbs would be right in your face so I wanted to soften that. This simple model was printed on the CR-10S diagonally to allow it to be a bit longer but can be trimmed to length after printing as needed. They are attached using Dollar Tree double sided tape (links below for reference). If you need the model shortened and don't know how to do it leave a comment and I'll upload a revision but I'd recommend trying MatterControl 2.0 which is super easy. Print with no raft/brim or support and infill shouldn't matter as it printed as all wall.

https://www.amazon.com/gp/product/B08G9H1KB1 https://www.dollartree.com/crafters-square-doubled-sided-tape-33ft/281210

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

No

Resolution:

280

Infill:

20

Filament: Any PLA