Charge Cord Protector V2 - bunnybeads

Version 2 of the bunny bead. Expanded to fit a 5mm cable and added a retention cover that snaps into place. Meant to cover the low voltage side of an HP laptop, but this may be my universal go-to for any cable smaller than 5mm.

print several dozen to cover charge cords that are in danger of being chewed by your loveable rodent pal that keeps asking to be made into stew. . These also help with being run over by a vacuum cleaner as has been demonstrated at least once.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

.2

Notes:

Printing primarily in PLA taking the bunnies gut into account.. a brim is prudent due to the small size and number that you may print at once.

Initially the cover was meant tp slide in from the bottom, but my daughter showed me up by snapping them in from the side. Much faster.

Category: Electronics