I designed these to be very very thin and have a small width to hold an organizer on a door. These have been holding strong for over a year now and the total weight on the 3 is about 30lbs.
I designed them to be extra thin where the door contacts the edge of the door frame so it doesn't obstruct closing.
I printed the hook on its side with no supports and it printed fine.
Dimensions:
Overall Width of hook= .250"
Width of thinnest part = .046"
Width of the tangs that hang down = .100"
Width between top of door and door frame = .050"
Length from top of door to hook = ~2.65
Printer:
Anet A8
Rafts:
No
Supports:
No
Infill:
100%
Filament: Any PLA Any
Category: Household
The author marked this model as their own original creation. Imported from Thingiverse.