Amazfit GTS Charging Stand

This is a charging stand for the Amazfit GTS smart watch. You may need to lightly sand the hole where the charger pushes in from behind to make it a better fit.

It needs to be tight but not so much it damages the charger. It will depend on your printer tolerances.

Print it on its side with supports in the hole ( I just selected supports everywhere in Cura ).

Print instructions

Category: 3D Printing Print Settings

Printer Brand: Monoprice

Printer: Select Mini

Rafts: No

Supports: Yes

Resolution: .175

Infill: 20

Filament: Sunlu PLA+ PLA+ Black Post-Printing

You may need to sand as required to make the charger fit snugly.