Stitching Pony

remix of thing:4373872 by shihong86

Fixed it so it is more mechanically correct and uses M6 hex head nuts and bolts.

M6 x 50 for the clam and angle adjuster. Table adjuster bolt length will depend on the thickness of your table but a 50 or 60 if its very thin.

Note: Plastic on plastic is very slick so it's a good idea to put something like thin rubber on one side of the adjuster so it will stay put.

0.2mm layers, 3 shells and 25% infill should do well. If you are ham fisted, do more shells.