Nesting TPU RC Road Cones, Self-righting

I wanted a set of road cones (I was using old tires but when you hit one they tend to roll away) for my RC car, with a few criteria:

1. Don't roll away when you hit them.

2. Next to carry easily (these stack on remote's antenna)

3. Print quickly, don't use a lot of material

4. Can get run over without serious damage by a full sized car

I would like to add a feature (tabs) so they lock together but I haven't bothered yet.

These bridges are just a BIT far, with the printer miscalibrated they don't come out perfect.

That said I've been using them for months and been very happy with them. It's nice to have a couple in different colors for "inside" cones.

Print Settings

Supports:

No

Filament:

Notes: