Ravenclaw Crest

This is a remix I did of a model on Thingiverse a few years back. The original was taken down, so I cannot credit the author, but they did a great job.

This is a minor remix of the original where I removed some weird geometries and holes. I also reduced the file size to 10% and 15% of the original size (200MB).

This is not a multi color model, I switched the filament a few times throughout the print.

Print instructions

Supports: No

To get the multi-color effect, I changed the filament a few times during the print.
0.0 - 4.0 - Gray
4.1 - 6 - Blue
6.1 - 10 - Gold
10.1 - 12 - Light Blue
12.1 - 15 - Blue

Note: These values would only work if printed at 100% scale and 0.10mm resolution.