Just resized Fredrik_JBE's design to fit crutches with Ø25mm (diameter).
I printed with PETG and 10% infill. Never tried PLA.
EDIT after using for a few days:
Tried using this - the distance between the the crutches needs to be increased since the top of the crutches cannot be so close together. Yet not as too far as to be annoying to use.
The hold on the crutches needs to be tighter. It was i the beginning, but got a bit looser in the end and it keeps on falling off. Maybe the hold on one side of the crutch needs to be more permanent than the other so the peace never falls off.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10%
Filament: Generic PETG White
Category: OtherThe author marked this model as their own original creation. Imported from Thingiverse.