Fideco SSD enclosure 3D printer bracket

This is a set of brackets that will secure a Fideco SSD enclosure on the the side of a 3D printer with 3030 extruded aluminum supports. I like to run my Raspberry Pis off of solid state drives (SSDs) so I designed this bracket so that I could secure an SSD onto my 3D printer and attach it the the Raspberry Pi which I have running Octoprint. I designed this bracket to point the SSD down a bit so that the cord can fit under the center part of the frame of the Prusa MK3S and get to the Raspberry Pi 4 which I have installed on the rear left of the printer. It was designed alongside this bracket for mounting a raspberry pi to the printer: https://www.printables.com/model/196338-3d-printer-mounting-bracket-for-raspberry-pi-in-al

Bill of Materials:

SSD in Fideco enclosure and cord

front and rear printed brackets

2x t-nuts printed

m3 hardware (2x 10mm screws and 2x hex nuts)

Amazon link to Fideco enclosure:

https://www.amazon.com/FIDECO-External-Enclosure-Adapter-Support/dp/B07W74BN5B/ref=sr_1_4?crid=15FOO400L6BIX&keywords=fideco+enclosure&qid=1651801617&sprefix=fideco+enclosur%2Caps%2C220&sr=8-4