Elephant Plant Pot with Drainage Snout

This model is a remix of Pezmc's relephant plant pot.  

I liked the idea of the raised platform letting the plants stay above water at the bottom, but then I noticed that the nose was plugged in that remix which could hurt plants in the long run.  
To top stagnant water from sitting under the plants and potentially getting their roots in it causing rot, I hollowed out the bottom a bit, made the nose hole larger, and then slanted the bottom underneath the platform to drain excess water out of the  elephant's nose. 

The platform from the original model works so I would download the platform there and then the elephant pot from this one, but I also included it in this print for ease of access.  Credit goes to @Pezmc for the platform!

Printing Instructions:

Print at ~20% infill at a low resolution for a quick print time.

Depending on how good your printer is at bridging, you may need to force supports between the legs of the elephant.

Be sure to print the drainage support upside down for a better print.

Made snout work for plants