A better holder for Xiaoimi Mijia T100 electric toothbrust

A better holder for Xiaoimi Mijia T100 electric toothbrust

I decided I make my own holder for Xiaomi T100 electric toothbrush. So far I have used another one but it was unstable, it was designed with very thin parts. It broke when it fell into the basin. I printed it several times. Then I (we, my family) just placed the toothbrushes into a glass. One of them broke down due to the water accumulating below. Then I designed this. I have set the following requirements:

• stability
• protection against accumulating water
• some acceptable look

I made several variants for those who need a holder for 2, 3, or 4 pieces of toothbrusts. I also made a couple of interesting composition.

I printed it by roteating it 120 degree backwards. So the pipes lie up exactly horizontally. Thereby, the minimum amount of support is required. In addition all the support will be on the back. Of course, after printing and removing the supports, post-production steps will be required. I don't know the reason, but always I suffer with the white PLA filaments. Lots of stringing regardless of the manufacturer or brand. There is no such problem with colored filaments. I used the tree type support in Cura. I like it. It is usually much easier to remove.

Print Settings

Printer Brand:

Anet

Printer: 

A8

Rafts:

Doesn't Matter

Supports: 

Yes

Resolution:

0.2

Infill: 

20%

Filament: c-tech PLA white

Notes:

My printer: Anet A8 Plus

My additional print settings:

Wall tickness: 1.2mm (Wall line count: 3)

Support:

• structure: Tree
• tree support branch angle: 42°

Important notice for the gcode files

I'm only uploading my gcode files to show the printing statistics. My printer is upgraded with a BLtouch sensor and modified firmware. So the gcode contains auto bed leveling. It may not work on stock printers!