Modified Voron 350 V2.4r2 Rear Center Panel Skirt

This is the Voron 350 V2.4r2 modified rear center skirt.

After printing the new revision 2 Voron V2.4 350 Rear center Skirt I wondered why they added so much plastic and didn't follow the standard skirts. I extended the standard design and removed most of the additional material necessary to print this part.

1. This part was created by Voron Design and is open source
2. No additional slicer setting needed apart from those suggested by Voron design.
3. No Supports needed

I have not done other sizes as they are much smaller.