zwProHolder – MacBook Pro 15" VESA Holder

Because space on desktop started to shrink drastically I decided to finally clean up everything, especially my MacBook Pro 15" (late 2013) which was taking too much space. I mostly using external monitors, mouse and keyboard so vertical placement of laptop was just taking so precious space. Because desk is standing at middle of room it would be hard to use any other vertical stands, anyone could easily push off my computer from desktop. Then I though that perfect place to put my MacBook would be VESA 100 mount at back of my monitor.

This solution not only solved my problem with space, only monitor was taking place on desktop, but also looks great.

This holder is going great with MacBook Pro Retina Connection Lock for cables. This allow we to setup my workspace in matter of seconds.

Remember to print it using with greater values of infill then normally, because your precious laptop is hanging on it!

Disclaimer You are using this print as it is. I'm not responsible if something happen to your computer. This holder is holding my laptop for like 3 months now, but I can't assure you that your printer would print this at same quality and it will stand some weight.

Print Settings

Printer Brand:

FlashForge

Printer:

Creator Pro

Rafts:

No

Supports:

No

Infill:

50%

Notes:

I have used ABS filament to print this holder, but you should be able to print it using any other filament.