Mini Disc - Rack

MiniDisk - Rack

Since I own a ton of MD's without any sleeves/cases around it I decided to make a Rack so they can fit in snuggly without the sleeves. There are 2 holes in the back of them so you can hang them up in 2 ways. If you like HoneyCombs I also included one so you can stack them up or make a honeycomb grid on the wall...

PLEASE NOTE! ONLY FOR MD's WITHOUT SLEEVES FIT IN IT!

No support is needed when printing. I even printed one with the front side on the bed to get that nice Prusa Textured PEI Sheet to look and the bridging was perfect!

I printed mine with FormFutura's Volcano PLA Black.

Support:
Doesn't Matter

Resolution:
0.2mm Layer Height

Infill:
10% Grid