Finalmouse Air58 Scrollwheel (SLA / DLP Recommended)

First off, this is HIGHLY RECCOMENDED TO BE PRINTED ON A SLA OR DLP PRINTER. See photos, the grey part was printed with a Prusa i3 Mk3S on 0.1mm layer heights. While there is potential with lots of tweaking, the resin part is hands down the winner here.

This part is a one to one exact replica, no changes were made to make it more printer-friendly or lighter.

This part is as close to dimensionally accurate as a $20 pair of calipers can get me.

Print instructions

Category: Electronics Print Settings

Printer Brand: Anycubic

Printer: Photon

Rafts: Yes

Supports: Yes

Resolution: 0.05