Sherpa/Dragon mount for HEVO

I wanted to use Sherpa mini and Trianglelab Dragon on my Hypercube evolution.

But i coudn't find the mount for it. So I've decided to give it a try and make my own.

The mount plate for sherpa/dragon has no space for end stops, if you want use them (as in oryginal design) you need to print x-carriage as wel. If not the mount plate should fit on standard hevo x-carriage.

Front plate is mixed from the sherpa mount I've found on official sherpa mini Github from annex-engineering. The cooling fans ducts are comming from the same design as wel.

If needed you can use BLTouch mount, but i dont really like this design.(It is too far away from the nozzle, but I didn't find a better place for it)

The offset is Y-70mm,X-0

Use wel heat resistant filament especially for blower mount(I used nylon)

Print Settings

Printer:

Artillery Genius

Rafts:

No

Resolution:

0.2

Infill:

25

Filament: Extrudr, Fiberlogy ASA, PA, Green TecPRO