REAR FRAME BRACE FOR LOWER ALL THREAD POLES

Hey Guys!

I was asked to remix this part in order to fit our wierdly different frame design. Myself and some other people have frames with a lower all-thread location than the standard. This makes it very difficult to find upgrade parts for us. So, I have remixed this one (thanks a lot @Leo_N).

Besides taking away part of the brace that was restricted by the all-thread I added spots to the base to be able to screw it down to a table/plywood board. and added a couple rounds (and my signature).

I am leaving this as a "work in progress" until someone else tells me that it works. I already have a different brace and will not be making this one right now.

Let me know if it needs anything else.

EDIT: 3/29/2018

I just uploaded a new model that allows you to tighten the nuts up to the brace. And added the test fit piece. So if there is a question of weather it will fit or not you don't have to make the entire part first.

EDIT: 4/2/2018

I have been asked to release a new model because of the linear bearings being obstructed by the top of the brace. In V2 I have lowered the top where the bearings are by 0.25" and left the top where the brace goes to the motor the same height. I have included a test fit piece so you do not have to print the entire thing to find out if it fits.