These fit my lighters nicely enough, but the pegs were smaller than the holes on my pegboard. I used a little heat to spread the two halves of the pegs and that seems to keep enough tension to hold it in place.
Lighter Tray for Pegboard
This is a lighter tray for pegboard. This tray can hold three lighters.
5
48
1
693
updated
May 4, 2022
Makes
Comments
@ThisisG
Thanks for sharing your make! Interesting how you warmed up the pegs and adjusted them. Please try using the STEP and F3D files I have published so you can change the design in 3DCAD.