Farm Playset

This farm playset is meant for your toddler starting from the age of about 2 years. Be careful toglue all pieces together so nothing gets loose for those little toddler's mouths!

The farm is meant to be printable without any supports and all pieces can be printed separately so you can print them each in their corresponding color and so you don't have to paint anything (or at least not a lot) afterwards. However I always provide the fully assembled piece as well to be printed a single color!

The Fence

For the fence you just need to print the assembled fence (I recommend with supports or you will have a little hang on the fence bars) or the parts separately. Then you would need to print the fence-bar and the post of the fence both twice.
Things to print:

• 2 x Fence bar
• 2 x Post of the fence
  The Tree (Apple Tree)

Again, for the apple tree you could print all at once or the pieces separate. Only thing that is always separate are the apples.
The trunk and the crown of the three needs to be attached together with one 24mm plug.
Things to print:

• 1 x Tree Trunk
• 1 x Tree Crown (with or without apples)
• 1 x 24mm plug
• 1 x Set of apples (if you printed the apple crown)
  A Sheep

For the sheep you will need the 12mm plug to plug the head and the body together. The legs of the sheep don't need a plug (however some glue is advised with kids). They fit really tight so it's better to plug in the legs before the head so you have some grip to give it the needed pressure to get them in.
Things to print:

• 1 x Sheep Body
• 1 x Sheep Head
• 2 x Sheep Legs
• 1 x 12mm Plug
  A Pig

For the pig you will need the 12mm plug to plug the head and the body together. The legs of the pig don't need a plug (however some glue is advised with kids). They fit really tight so it's better to plug in the legs before the head so you have some grip to give it the needed pressure to get them in.
Things to print:

• 1 x Pig Body
• 1 x Pig Head
• 2 x Pig Legs
• 1 x 12mm Plug
  A Cow

Soon to come...

A Chicken

Soon to come...

Print instructions

Category: Playsets Print Settings

Printer Brand: MakerBot

Printer: MakerBot Replicator Mini+

Rafts: Yes

Supports: No

Resolution: 0,20mm

Infill: 20%

Notes:

Supports are not needed if you print the pieces separately and join them together with the right pins.
All of the pieces (as they are on the photo's) are printed with an infill of just 20%, also the plugs. The stronger you want the toys to be, the more infill you should print with!

The Fence

• 2 x Fence bar

• 2 x Post of the fence
  The Tree (Apple Tree)

• 1 x Tree Trunk

• 1 x Tree Crown (with or without apples)
• 1 x 24mm plug

• 1 x Set of apples (if you printed the apple crown)
  A Sheep

• 1 x Sheep Body

• 1 x Sheep Head
• 2 x Sheep Legs

• 1 x 12mm plug
  A Pig

• 1 x Pig Body

• 1 x Pig Head
• 2 x Pig Legs
• 1 x 12mm Plug