ITEM light T-Nut M4

ITEM T-Nut M4 ( Nut 8 )

This T-Nut M4 for ITEM light profiles was designed for a DIY laser cutter project.

The T-Nut is accurately designed, so that it fits well into the groove, but does not slide down like other T-nuts.

So the stone stays in position and it can easily side parts etc. are mounted.

(+) very precise and form-fitting

(+) No twisting or tilting

(+) high stability if the infill is increased accordingly

(+) T-nuts do not fall down even in a vertical position

(-) fits only ITEM light profiles, otherwise all positive points will get worse

alternative T-nuts:

--> M5 T-Nut: https://www.thingiverse.com/thing:2771480

--> M3 T-Nut: https://www.thingiverse.com/thing:2773072

Print Settings

Printer Brand:

MakerBot

Printer:

MakerBot Replicator 2X

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0,2 mm

Infill:

min 15%

Notes:

The T-Nut was printed in a resolution of 0.2mm to ensure the accuracy of the 8mm groove.

The infill was set to 15%, which has given a good stability, but can be increased as needed to get a higher stability.