adjustable Stepper Mount Nema 17

adjustable Stepper Mount Nema 17

This adjustable Stepper Mount was designed for a DIY laser cutter project.

The Stepper Mount is fixed with two M4 with 20mm screws and T-Nuts.

The case itself is attached to the item profile with two M4 screws and the matching M4 T-Nuts. With the upper screw, the endstop can now be precisely adjusted

(+) adjustable X,Y & Z axis

(+) very precise and form-fitting

(+) high stability if the infill is increased accordingly

(-) only for Nema 17 steppers & and in shape the same stepper

-> The x-axis can be adjusted with the offset of the Item Profile from a line.

-> The y-axis can be adjusted via the two M4 fixing screws.

-> The z-axis can roughly be made by changing the direction of the item profile and fine by moving the gear on the stepper axis.

The Stepper Mount was attached here with two M4 T-Nuts and can be downloaded here: https://www.thingiverse.com/thing:2770009

Print Settings

Printer Brand:

MakerBot

Printer:

MakerBot Replicator 2X

Rafts:

No

Supports:

No

Resolution:

0,2mm

Infill:

18%

Notes:

Hi Guys,

The stepper mount was printed with 20% infill, as the intended application is higher than usual.

(1.27m x-axis & extreme pull on the long Riehmen)

if your space in the project is smaller, 10-15% must be enough.

cheers ;-)