Lego Star Wars UCS Slave 1 (75060) Wall Mount

This design allows you to wall mount your Lego Star Wars UCS Slave 1 vertically. After printing I had to file all the corners as my printer doesn't quite make them square.

I probably over-engineered this as I'm paranoid about it jumping off the wall! It uses two of the mounting holes from the original stand, plus four other locations. I also added holes for one or more Lego Technic pegs to hold the mount onto the ship. To fit: -

1. Sand any bumpy edges on the mount square.
2. Remove engines (which just pop out).
3. Remove (or fold up) t-piece between engines.
4. Fit ship side mount.
5. Fit one or more technic pegs (one is fine).
6. Slide onto wall side mount.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: Sunlu PLA

Notes: