ESP8266 WeMos D1 Mini Slim Case

UPDATE: Added a "Rugged" version with clips (pretty flimsy, take care) for an increased holding strength.

A very slim case for the WeMos D1 Mini

DISCLAIMER: I've designed this case to fit my WeMos board with very small tolerances. I hope it will fit as many boards as possible, but I'm sorry if it doesn't. Just test it and see!

If you only need a small enclosure to protect and to make your WeMos board look better, this one is for you!

I recommend printing the first layer with a higher flow rate to squish the material to the bed so the surface will look beter. Also, I've printed mine with a 0.1 layer height but I think a 0.2 will do as well.

...If you also need the pin headers, just tell me and I'll try to adapt the design...