80mm Fan Mount & Cover

I needed a fan mount for the inside and outside of a custom made enclosure, and nothing out there fit. This is designed to mount an 80mm DC fan, in either direction. The fan mount itself needs to have support, but the fan cover does not.

There are inset holes for M3 nuts as well, and this will sit flush against a 1/2 inch piece of MDF, plywood, etc. I use a #10 screw to mount to the wood.

The fan cover is press fit, allowing you to remove the filter quickly. You don't have to be super exact when cutting out the hole for the fan, since this covers both sides, cleaning up the look!

Print instructions

Category: Electronics Print Settings

Printer Brand: MK3

Printer: Prusa i3

Rafts: No

Supports: Yes

Resolution: 0.150

Infill: 35%

Filament: Prusament PETG Jet Black
Notes:

I printed at 0.150mm, but you could print at 0.2mm or higher and it should be fine.