Hand-Screw Clamp +10mm length +standing

Remix from jakejake's Hand-Screw Clamp https://www.thingiverse.com/thing:2403756

I extend the jaw by 10mm, add 2 flanges so the clamp can stand up on itself at horizontal/vertical position.

I also "patch" the the narrow gap of original design. Narrow gap is still there, serve as forced-wall reinforcement structure, just hide below the surface.

You can also use other good remix part such as:

blu3lit3's Pads with Cut Pattern https://www.thingiverse.com/thing:2440099

CSlawek's Hand-Screw Clamp - Long Threads https://www.thingiverse.com/thing:2504394