Scooter / Bike Phone Stand Mount (M365)

STLs

All files are in correct Z orientation

• Main (Use one of the following) +main.stl (for ~22.5mm handlebar) +main-short.stl (shorter stem) +main-32mm.stl (for ~32mm handlebar)

*jaw.stl *screw.stl

• Clip (Use one of the following) +clip.stl (for ~22.5mm handlebar) +clip-with-loop.stl (use this if you want to hang a bag on your scooter that uses velcro loops, and you don't have any space left on the handlebar) +clip-32mm.stl (for ~32mm handlebar)

Screws & Nuts

*4x M4x20 *8x 10mm Washers *4x M4 Nuts *1x M4x50 (screw this inside the printed screw to strengthen it)

About the design

This is originally designed to fit Xiaomi M365 Pro scooter which has ~22.5mm diameter handlebar. But should fit on most bikes or scooters that have a straight handlebar. It needs 45mm of handlebar space. Phone sizes I've tries are from small iphone 5 to large "max" sized iphones.

If you need a custom size...

Comment if your handlebar is much bigger than 22.5mm, and i can give you updated STL. :)

My handlebar diameter is 22.5 mm, but it should fit few mm bigger handlebars as well. For smaller diameter, you can use rubber padding.

Print Settings

Rafts:

No

Supports: 

No

Resolution:

0,3 or less

Infill: 

20% or higher

Notes:

No supports needed, and all files are in correct Z orientation. For extra strength increase Perimeters to 3 (or more) instead of infill (20% is enough).

Category: Mobile Phone