Skilsaw Jobsite Featherboard

This featherboard works for the Skilsaw Jobsite tablesaw. It uses a 5/16 2" bolt and a nut. The original version did not push far enough toward the blade to give a thin cut, so I had to extend the board a couple inches. I also adjusted the miter bar to lock onto the miter groove, otherwise the featherboard would slide.

I printed this in Rainbow PLA. If you print in ABS I am not sure how the shrinkage would affect the miter slide action.

Print instructions

Category: Machine Tools Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 10%