HJV SpoolHolder & Rail

When I builded my printercabinet, I had a brainfart making of an spoolholder, what is attached on a rail and the rail is attached on the cabinets sidewall. Then the spoolholder could be moved from front to back ways if needed.

Rail: 280x41x10mm

Rail holes: 3x4,5mm

SpoolHolder: 30x78,4/35x115mm

Spool max. width: 90mm

31.1.2019

SpoolHolder with roller

Spool max. width: 84mm

Bearings: 608 / d8mm / D22mm / B7mm x2

In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

No

Resolution:

0,2mm

Infill:

10-20%

Filament: Real PLA / PETG

Notes:

Rail printed with 4 shells and 3 top/bottom. Holder 3 shells, 4 top/bottom.

In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.

Category: 3D Printer Accessories