Sony Bravia XH81 under-screen soundbar mount for Lenco SB-080

This is a pair of support brackets that allow to mount a Lenco SB-080 soundbar just below the screen of a Sony Bravia KD-43XH81. The brackets mount to the TV where the stands would usually be, so obviously you will need to wall-mount your TV.

The mounting procedure is to first screw both supports to the TV; then insert the soundbar from the back opening (the parts are flexible enough to allow this) and then fix the soundbar in place by using cable ties as shown in the picture. My suggestion is not to nip off the cable ties for the first few days, so that if the printed parts yield a bit, you can adjust by tightening the cable ties.

I cannot guarantee compatibility with any other TV or soundbar.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

30

Filament: Generic PLA Black

Notes:

I printed the parts using 6 walls and 30% infill, at 0.2 mm layer height. Supports are (just barely) not needed. Print time is about 3 h 30 min total for both parts.