Coolant and washer bottle mount

This is a mount I built to hold two 800ml bottles side by side and mount a small windshield washer pump. I'm using 1/4" foam on the bottom and sides and two long zip ties to hold them in place. Printed with support and it was a bit finicky to get the support out of the holes meant for the zip ties. It might print without supports. I printed mine in PETG on an Alphawise U20 put will fit on an Ender 3 sized printer. With .32 layer height, .5 line width and 20% infill, sliced in Cura it took about 12 hours to print.

Please watch the video for more information as far as what bottles I used, what pump, etc, etc.