Calibration Cube&Circle 10mm and 20mm Version with Peg
Just an extra step to check how well the printer makes for a precise fitting. This version has a lenient 7.8mm…
0
29
0
151
updated May 1, 2022
Description
PDFJust an extra step to check how well the printer makes for a precise fitting. This version has a lenient 7.8mm diameter peg, so if your printer is calibrated well, the peg should go through the hold unimpeded.
All I made was the little peg. See xammax's part for the original piece.
Category: 3D Printing TestsTags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
