Nozzle Box for E3D Revo Six (print-in-place) - different versions

Object Description:

This is a print-in place storage box for E3D Revo Six nozzles.

Following versions can be downloaded:

• 4 nozzle version for brass nozzles 0,25 / 0,40 / 0,60 / 0,80
• 5 nozzle version for brass nozzles 0,15 / 0,25 / 0,40 / 0,60 / 0,80
• 7 nozzle version for brass nozzles 0,15 / 0,25 / 0,40 / 0,60 / 0,80 & ObXidian 0,40 / 0,60
• 2 nozzle version for ObXidian 0,40 / 0,60

The nozzle sizes are marked on the base part.

I recommed to print it in two colours. For this reason one 3mf-file for each version already includes two colour change codes.

Single-colour versions are also available.

The lock goes a bit hard at the beginning to cover wear over time. In case it is too hard, you can slightly sand it.

The inlet depth on the lid is theoretically 0,7mm. But printed without support, it will be less in practice. For this reason the inlets are provided with a thickness of 0,4mm. If you need a different height, please scale it in the Z direction for the best fit.

I haven't tested it yet, but I'm sure it will be difficult to insert the ObXidian inlet. Scaling in X/Y direction will not work. I think it will help to modify the elephant foot compensation and to reduce the first layer thickness. I hope friendly users will report successful settings.

Update 2022-12-15:

7 Nozzle version for 5 brass nozzles and 2 ObXidian nozzles added.

Update 2022-11-25:

Nozzle sizes at ObXidian nozzle versions corrected. Apologize to all who may printed the version with the wrong marking. Many thanks to Fred80 for the hint.

Update 2022-10-19:

5 Nozzle version and 2 ObXidian-Nozzle version added.

Print settings:

Material: PETG, ABS/ASA, PLA

Layer height: 0,2mm

Infill: 15%

Perimeters: 3

Brim: no

Support: no