Twister servo winch

Base and spool for an RC4WD Twister servo.

This is the easiest to mod servo I have yet seen! Pull the output gear stop pin, remove the circuit board, unclip the pot, cut away its mount, cut open the case end or side, done!

Printed base includes mounting for a 5x11x4 bearing, std on most crawlers and a secondary mount tab for mounting options.

Spool uses an M3 set screw.

M3x50, lock nut and M3x7mm washer for main shaft.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

No

Resolution:

0.16

Infill:

25%

Filament: Inland PLA