EasiYo Yoghurt maker replacement lid outer

My EasiYo yoghurt maker lid fractured due to heat and UV damage, so instead of going to a shop to buy a replacement (now in multiple colours!), "I make a new one".

This is a simple OpenSCAD hull() design which fits nicely on the original red inner part of the lid replacing the outer shell. There is a polystyrene disc insulating disc sandwiched in the middle, which was a bit snug so v2.0 has an extra 5mm of height.

The outer curves are gentle to allow printing without supports.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Infill:

Low for insulation

Notes:

Prints without supports upside down.

I used black PETG filament, as that's was in the Ender 3v2 printer. White perhaps would be better!

How I Designed This

This is a simple OpenSCAD hull() design - three cylinders 'wrapped', then repeated slightly smaller to carve out the inner.

Category: Kitchen & Dining