Braava Jet 240 Crash Helmet

Are you sick and tired of yourBraava Jet 240 (or 245 like I have) getting stuck under yourfridge door ordish washer door?

Well, fret no more, this easy to printfront bumper will make all that a thing of the past. Just print it and snap it in place.

PS: rumor has it that this makes your Braava Jet500% smarter

NOTE I discovered after using this helmet for a while that if you print it with too much infill, like I probably did (20%), the weight of it, plus the braava's internal water tank, may affect the balance of the little bot causing it to stutter and have trouble moving about. So, print it with less infill since there is no real need for this to be super strong. And when your bot is wearing this helmet, maybe fill the water tank only to half full (approx).

UPDATE Mar 2018 Because of the above note, I revised the design to make the helmet now less than half of the weight of the original helmet (when printed with 5% infill). v2 of the helmet works much better on my little bot.

Print Settings

Printer:

Craftbot

Rafts:

No

Supports:

No

Resolution:

0.2 mm layer height

Infill:

5%

How I Designed This

Designed in Fusion 360