Ratrig V-Core 3 Chunkier X Endstop Block

I ended up using a normal microswitch for my X Endstop (only two wires needed in the umbilical) and the stock endstop block was a bit too low.

This is a slightly (3mm) taller version and whilst at it, I increased the width & thickness of the slot to permit the use of a washer and make it less susceptible to deforming.

Print Settings

Printer Brand:

LulzBot

Printer:

TAZ 6

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20% Triangle

Filament: Any Any (except TPU!). Any How I Designed This ===================