Hammer Nut or T-Nut Tool with magnet 2020 extrusion

I wanted a tool to help me position a hammer nut when the part is already attached, or access to the hammer nut where placement is difficult. This tool uses a tiny 3mm x 1mm magnet in its tip to hold the nut in place while the bolt is driven in. The magnet is also handy for pulling out nuts that get lost in the slot under a part. Print with the large flat down, no support needed.

Print Settings

Rafts:

Doesn't Matter

Supports:

No

Resolution:

.02

Infill:

80%

Notes:

Print in same orientation as .stl and it will need no support

Post-Printing

Parts Needed:

1 tiny magnet 1mm x 3mm or break a small chunk off a fridge magnet (?)
1 drop of glue to keep the magnet in place.

1 toothpick to place the drop of glue and position the teeny magnet.

0 pliers, the magnet will stick to the pliers!