Spice Jar

I needed a number of small spice jars to take spices with me to baking class. The design by Terminus was very close to what I needed, but I just needed a solid lid without the "shaker holes".

After several attempts at remixing, my printer kept spitting out versions with multiple printing errors. I tweaked, and adjusted, and re-sliced my new design so many times, I was ready to give up. I just couldn't get a smooth print, I kept getting weird inclusions on the exterior of the prints.

Doh .... my fault .... I made a few serious errors in Tinkercad (both design and alignment) so when the shape was "sliced" the software created all kinds of weird inclusions along the outside perimeter.

But it's all fixed now with this version.

This began is a 40mm x 30mm jar with a solid lid, (the lid is a "snug" fit, but comes off with a firm twist), but ended up as a 30mm, 60mm, and a 90mm version.

Print Settings

Printer Brand:

TEVO

Printer:

Tornado

Rafts:

No

Supports:

No

Resolution:

.25mm

Infill:

25%

Filament: Inland PLA+ Any

Notes:

I print mine WITHOUT a solid bottom, both to save time & filament and the "Infill" pattern gives an interesting look to the jars.