Filament Drybox Bowden Tube Organizer

This clip holder helps to keep the bowden tubes of my drybox orderly when they're not connected to the extruder. The slots are just a bit bigger than a regular 4 mm outer / 2 mm inner diameter teflon tube for 1.75mm filament. The tube is anchored by its own springiness against the triangles in the middle. Attached to the drybox by three 4mm Ø / 8mm length allen screws with washers directly into the square holes of the PLA.

Print Settings

Printer:

TronXY X5S

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.6 mm nozzle, 0.4 mm layer height

Infill:

15% honeycomb

Notes:

Sliced with 3 outer shells.