Lubitel 166 Lens Hood

Hate flare ruining your nice film photos or want to make that collectors Lubitel look like it actually works? Look no further than this lens hood. Helps cut down on flare and doesn't show up in photos when printed.

Depending on your clearances, you may want to scale it up to 101% or 102% as mine fit, but it was a chore getting it on and off. Recommended filament of TPU but PLA or ABS should be just fine too.

Enjoy your crisp flare free photos now!

Print Settings

Printer:

Artillery Sidewinder X1

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.25

Infill:

15-25%

Filament:

Black

Notes:

I used Ziro TPU, with no support, but recommend either using rafts or brim to keep it attached to your build plate.
Print Speed of 35mm/s. Retracts off; combing mode: "Not in Skin"

TPU temp of 215, build plate temp 60-65.

How I Designed This

Easy Peasy lens hood in Fusion 360

1. Take diameter of outside of lens
Sketch circle (diameter of lens) and square you want for the outside box of hood. Offset square (20mm) in Y or X direction according to how you sketched it. Use "Loft" command to join circle to square Use "Shell" command to remove the insides to the thickness you want. Export and send to Cura Upload to Thingiverse.