Ikea Skadis iPhone XS holder with Qi charger

Use your phone as display in portrait or landscape orientation while charging on your Ikea Skadis pegboard.

I designed this model around an older Qi charger board that i had, but since this is a separate piece to print you can design your own for the ones that you can buy on Aliexpress today. The Fusion 360 source is provided.

Print:

• the phone holder
• 2 hooks
• the Qi coil holder
• the electronics board holder (only if you have the same as me from 2015!). Design your own for recent models.

To assemble the pieces i used sealant but super glue should be fine too. Sorry, i didn't have the modeling skills to make it just fit without glue.

If you have suggestions about how i should design things differently in Fusion 360 i'm open for comments, because i'm still learning on my own.