E3D V6 Raised Dwarfstruder

Here is a mash up of the Dwarfstruder and Raised J-head mount for use on the Ord Bot Hadron. It has been modified for using an E3D V6 hotend, so the slot for the head is thinner than the standard J-head. Designed for 3mm filament. Fins have been added in an attempt to keep drafts on build area from the fan minimized. Uses original resin fan mount on hotend. Like the dwarfstruder it utilizes the 2engineers 1:50 geared stepper motor and various metric nuts and bolts, springs, etc.

Update: 12/31/2014

• Realized that most recent changes to base were done on a standard J-Head slotted base. Using the V6 E3D Hotend introduces wobble in the head due to height differences in the slot, testing updates now and will upload new files after testing is completed.

Udate: 12/28/2014

• Lowered fins to give more clearance for fan shroud.
• Fixed up the base guidler hinge mount to fix some poor modeling and reduce inner hole diameter to proper size.
• Increased length of the guidler arm for better alignment with screws.
• Mirrored guidler to put nut trap on side with stepper motor for easier assembly.
• Incorporated guidler screw bar to make filament change a little easier on the fingers (inspired by litwon's quick release lever for wade).
• Radiused top of guidler to assist with use of above mentioned guidler screw bar.