Cr-10S Pro/Cr-10 Max TFT35 V3.0 Mount

Best of both worlds: Touch screen display + emulated 12864. I designed this in anticipation of upgrading my machine to a 32-bit board (SKR Pro) and TFT35 V3.0. Uses the concept and mount plate from Nitec0re's design, but pretty much a redesign from there up. ~~I don't have the parts yet, so I'm not sure yet if everything fits.~~

Update 6/12/19:

Minor rework on TFT35_Mount_v3.stl file to reduce the gap between it and the case.

Update 19/1/2020:

I probably should have mentioned you will need 12 m3x6 screws. See comments section for brief assembly instructions.

Update 29/1/2020:

Finally got the board in my hands and modified several things: Enlarged both SD card and USB openings; relocated mount holes that were interfering with board plugs; relocated cable feed slot

Print Settings

Printer Brand:

Creality

Printer:

CR10S PRO

Resolution:

.4

Infill:

20

Filament: Overture PETG Red

Notes:

Support required for mount, but may not be necessary for the case - it depens on whether your printer can handle a 25mm bridge. Be careful removing the support from the mount; the bottom brace is somewhat thin.

Uses stock hardware to attach the mounting plate inside the machine case.Mount with the cutout toward the bottom of the printer. Requires 4-M3x6 screws to attach the board to the case, 4-M3x6 screws to attach mount to the plate and 4-M3x6 screws to attach case to mount.